您的位置:首页-公司动态 - 公司资讯

东莞哪里的24V2A国标CCC认证电源适配器最便宜?

发布时间:2019.07.15 新闻来源:电源适配器厂家|批发充电器|LED驱动电源厂家-东莞市昂创电子科技有限公司 浏览次数:
东莞哪里的24V2A国标CCC认证电源适配器最便宜?

24V2A国标CCC认证电源适配器, Max.Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point.
电压比较大纹波/比较大噪音
Voltage Ripple and Noise(Max.)
+9Vdc 150mV p-p
3.4 启动延迟时间/Turn on delay time:
当输入115Vac和输出比较大负载时,比较大启动时间为3S.
3Second Max.at 115Vac input and output Max.load.
3.5 上升时间/Rise time:
当输入115Vac和输出比较大负载时比较大时间为40 mS.
40 mS Max.at 115Vac input and output Max load.
3.6 保持时间/Hold up time:
当输入115Vac 和输出比较大负载时,相当小保持时间为5 mS .
5 mS Min.at 115Vac input and output Max.Load.
3.7效率/Efficiency:
当115/230Vac输入电压时,1/4,1/2, 3/4和满载计算平均效率,相当小80.29%.
80.29%Min,At 115/230Vac input voltage,国标CCC认证电源适配器,1/4, 1/2, 3/4 and full load calculation average efficiency.

输出特性/OUTPUT CHARACTERISTICS: 3.1 输出功率/Power output 电压 Voltage 相当小负载 Min. Load 额定负载 Rated. Load 峰值功率 Peak 输出功率 Output power 5.5-24 0.01A-4A 0W 2 负载特性,调整率/Combined Load/Line Regulation 电压 Voltage 相当小负载 Min. Load 额定负载 Rated. Load 线性调整 Line Regulation 负载调整率 Load Regulation 5.5-24Vdc 0.01A-4A ±2% ±5% 3.3 纹波和噪音Ripple and Noise: 测试条件:在输入115/230Vac 和输出相当小及比较大负载时,使用示波器带宽为20MHz 连接到适配器的输出端,同 时输出端并联一个47uF的电解电容和一个0.1uF的瓷片电容. At 115/230Vac input and output Min and Max.Load, the ripple and noise are as follows when measure with Max.Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point. 电压比较大纹波/比较大噪音 Voltage Ripple and Noise(Max.) +5.9Vdc 120mV p-p

3.4 启动延迟时间/Turn on delay time: 当输入115Vac和输出比较大负载时,比较大启动时间为2S. 2Seconds Max.at 115Vac input and output Max.load. 3.5 上升时间/Rise time: 当输入115Vac和输出比较大负载时比较大时间为40 mS. 40 mS Max.at 115Vac input and output Max load. 3.6 保持时间/Hold up time: 当输入115Vac 和输出比较大负载时,相当小保持时间为5 mS . 5 mS Min.at 115Vac input and output Max.Load. 3.7 效率/Efficiency: 当115/230Vac输入电压时,1/4,1/2,3/4和满载计算平均效率,相当小77.65%。 77.65%Min, At 115/230Vac input voltage,1/4,1/2,3/4 and full load calculation average efficiency. 适配器满足能效V。 Adapter meet efficiency lever V。

24V2A国标CCC认证电源适配器, 测试台面是厚13mm的夹木板,离地面高19-20mm
The horizontal surface Consists of hardwood at least 13mm thick,mounted on two layers of plywood
each 19mm to 20mm thick,all supported on a concrete or equivalent non-resilient floor.
6、安全及EMC要求/SAFETYAND EMC REQUIREMENT:
6.1 安全:符合标准:EN 60950
Safety:accord standard with: EN 60950
6.2 高压/DIELECTRIC STRENGTH Hi-Pot:
初级对次级/Primary to secondary: 3000Vac/10mA/60S or 4242Vdc/5mA/60S for type test.
6.3 绝缘抗阻/Iusulation resistance:
初级对次级/Primary to secondary:20MΩ min at 500V DC.
6.4 EMI标准/EMI STANDARD
Meets the Limits of/测试符合
<1>.Fcc part15 class B rules
<2>.EN55022 class B rules
<3>.GB9254-1998,GB17625.1-2003
安规认证符合:CE、GS、CB、UL、FCC、CSA、BS、SAA、CCC、PSE、KC

电源适配器厂家|批发充电器|LED驱动电源厂家-东莞市昂创电子科技有限公司!
本文共分 1
分享到:
上一篇:哪些电源适配器要做CCC认证?
下一篇:没有了
相关文章: